Sennheiser XSW-D VOCAL SET Specs

System
Frequency Range 2.400 to 2.483 GHz
Latency
Transmission Range 250′ / 76.2 m (Line of Sight)
Simultaneous Operation of Units Up to 5 Systems Simultaneously
Frequency Response 80 Hz to 18 kHz
Signal-to-Noise Ratio ≥106 dB
THD
Modulation GFSK with TDMA
Operating Temperature -10 to 55° C / 14 to 131° F
Relative Humidity 95% (Non-Condensing)
Transmitter
Type Plug-On Transmitter
Input Connector XLR-Female
Phantom Power No
RF Output Power 10 mW
Microphone Max Input Level Mic-Level Input Only: 1.2 dBu (Typ. 0 dBu)
Battery Type: Built-In, USB-Rechargeable, Lithium-Ion
Battery Life: 5 Hours
Charging Time: 3 Hours (Typical)
Charging Cycles: Up to 1000 Cycles
Nominal Voltage: 3.7 V
Cell Capacity: 850 mAh
Input Voltage: 5.0 V (Typical)
Charging Temperature: 32 to 140° F / 0 to 60° C
Dimensions 4.0 x 0.9 x 1.1″ / 102 x 24 x 28 mm
Weight Not Specified by Manufacturer
Receiver
Type Plug-In
Output Connector XLR-Male
Audio Output Level Consumer Line-Level Output Only: -12 dBu (Maximum)
Battery Type: Built-In, USB-Rechargeable, Lithium-Ion
Battery Life: 5 Hours
Charging Time: 3 Hours (Typical)
Charging Cycles: Up to 1000 Cycles
Nominal Voltage: 3.7 V
Cell Capacity: 850 mAh
Input Voltage: 5.0 V (Typical)
Charging Temperature: 32 to 140° F / 0 to 60° C
Dimensions 4.3 x 0.9 x 1.1″ / 109 x 24 x 28 mm
Weight Not Specified by Manufacturer
Microphone
Type Handheld
Polar Pattern Cardioid
Transducer Principle Dynamic
Frequency Response 55 Hz to 16 kHz
Connector XLR-Male
Impedance Nominal Impedance: 300 Ohms (At 1 kHz)
Terminating Impedance: 1 kOhm (Minimum)
Sensitivity 1.8 mV/Pa (Free Field, No Load at 1 kHz)
Temperature Range 32 to 104° F / 0 to 40° C
Dimensions (Ø x L) 1.9 x 7.1″ / 48 x 180 mm
Weight 0.73 lb / 330 g (Without Cable)
Packaging Info
Package Weight 1.65 lb
Box Dimensions (LxWxH) 9.5 x 9 x 2.7″